Advantech RS-485 Manual de usuario descargar pdf (Pagina 319)

100

101

ADAM-5000 C-7

Appendix C

Figure C-5 Signal distortion

The value of the resistor should be a close as possible to the charac-

teristic impedance of the line. Although receiver devices add some

resistance to the whole of the transmission line, normally it is sufficient

to the resistor impedance should equal the characteristic impedance of

the line.

Example:

Each input of the receivers has a nominal input impedance of 18 kΩ

feeding into a diode transistor- resistor biasing network that is

equivalent to an 18 kΩ input resistor tied to a common mode voltage of

2.4 V. It is this configuration which provides the large common range of

the receiver required for RS-485 systems! (See Figure C-6 below).

1 2 ... 314 315 316 317 318 319 320 321 322 323 324 ... 347 348

Comentarios a estos manuales

Sin comentarios

Advantech RS-485 Manual de usuario Pagina 319

Comentarios a estos manuales

Relacionado con productos y manuales para Digital + i / s analógicas módulos Advantech RS-485