Advantech RS-485 Manual de usuario Pagina 225

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 348
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 224
ADAM-5000 6-103
Chapter 6
$aaSiCj3hh $aaSiCj3hh
Name Trim Calibration
Description Trims the specified channel a specified number of units
up or down
Syntax $aaSiCj3hh(cr)
$ is a delimiter character.
aa (range 00-FF) represents the 2-character hexadecimal
address of the ADAM-5000 system.
SiCj identifies the I/O slot i (i : 0 to 3) and the channel
j (j : 0 to 3) of the module you want to calibrate.
3 is the trim calibration command.
hh is the 2-character twos complement hexadecimal
value that represents the number of counts by which to
increase or decrease the output current. Each count
equals approximately 1.5µA. Values range from 00 to 5F
and from A1 to FF (hexadecimal), where 00 represents 0
counts, 5F represents +95 counts, A1 represents -95
counts and FF represents -1 counts. Negative values
decrease and positive numbers increase the output
current according to the number of counts.
(cr) is the terminating character, carriage return (0Dh)
Response !aa(cr) if the command is valid.
There is no response if the module detects a syntax error
or communication error or if the specified address does
not exist.
! delimiter character indicating a valid command was
received.
aa (range 00-FF) represents the 2-character hexadecimal
address of an ADAM-5000 system.
Vista de pagina 224
1 2 ... 220 221 222 223 224 225 226 227 228 229 230 ... 347 348

Comentarios a estos manuales

Sin comentarios