
6.3.2 Activate HPM FW image
Although the new IPMC FW is successfully downloaded to the board (called
“deferred” version), it needs to be activated before it will be functional. Use
following HPM.1 command:
During the FW update the front panel FRU LED’s 1 and 2 (red OOS and green
payload LED) are flashing! This procedure needs around 30 seconds to finalize
the update. It will need an IPMC reset to complete the FW upgrade.
The user can detect an upgrade failure with an Integrity sensor event.
6.4 FPGA Upgrade
6.4.1 Upload new FPGA image
TypeIPMItoolHPM.1upgradecommandandselectthenewIPMCfirmware
image.
[root@localhost ~]# ipmitool hpm activate
PICMG HPM.1 Upgrade Agent 1.0.2:
Waiting firmware activation...OK
Comentarios a estos manuales