Advantech MIC-5332 Manual de usuario descargar pdf (Pagina 62)

<1.1> Supported LAN interfaces

Four of MIC-5332’s Ethernet interfaces can be used for Serial over LAN:

‐ Base interface channel 1/2

‐ I/O interfaces 1/2

The LAN controller for NCSI is powered by management power and provides

access to the management part over LAN even if payload is powered off.

<1.2> LAN Controller and UART MUX configuration

The LAN and UART configuration of the BMC is flexible and allows different

configurations. To avoid “wrong” setups, users should always verify the actual

LAN and UART configuration settings (chapter <x.x.x - Configuration Setting

OEM commands>), before working with SOL:

1.) Select the LAN interface to be used (IO or Base interface)

2.) Make sure the LAN channel priority is appropriate

3.) Select OS UART interface to be used (tty0 or tty1)

<1.3> Default Parameter

Following default parameters are good to know for the initial MIC-5332 LAN

setup:

IP-Address: 192.168.1.1

LAN Channel Number: 5

Username: "administrator"

Password: "advantech"

<2> LAN Configuration with IPMItool

The open source IPMItool utility is used in this chapter for the MIC-5332 SOL

and LAN parameter configuration. Any other utility, based on standard IPMI

commands, can be used as well.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 128 129

Sin comentarios

Advantech MIC-5332 Manual de usuario Pagina 62