Advantech MIC-5332 Manual de usuario descargar pdf (Pagina 59)

console communication with the payload over a LAN interface (See Section 4.2.1.4,

NC-SI Interface). The SoL function is available for I/O LAN (LAN1 & LAN2) and the

Base Interface, but not simultaneously. Each of these two interfaces uses the Intel

quad port LAN controller Intel i350-AM4, and supports the failover mechanism: As

one channel in use is unexpectedly disconnected from the network, the IPMC will

switch and re-establish the SoL session to the other channel within the same LAN

controller automatically, to ensure the serial data in transmission will not be influenced

by a link failure.

Figure 4.3 SoL Functional Block Diagram

The IPMC configures the LAN controller through the NC-SI interface and sets it in a

“pass through” mode, meaning that it can send and receive Ethernet frames through

the LAN controller. In this mode the GbE controller will use a dedicated MAC address

to send and receive packets intended for the IPMC.

4.6.2 SoL Preparation

4.6.2.1 IPMItool

IPMItool is a utility developed to support the IPMI specification. It provides a simple

command line interface, allowing users to easily establish the management

application, e.g. read the FRU information, get the sensor data record, configure the

LAN parameters…etc. The IPMItool utility is available in both Windows and Linux

versions, and the installation procedure is described as follows:

For Windows users:

1. Open the IPMItool folder. (CD path: \IPMItool\Windows)

2. Put “cygwin1.dll”, “cygcrypto-0.9.8.dll” and “ipmitool.exe” under the same folder in

the terminal PC.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 128 129

Sin comentarios

Advantech MIC-5332 Manual de usuario Pagina 59