Advantech MIC-5332 Manual de usuario descargar pdf (Pagina 35)

3.4 Installing the MIC-5332

3.4.1 MIC-5332

To install MIC-5332 into the chassis:

1. Leave the ejector handles in the open position.

2. Choose a node slot in chassis, and align the PCB edge to the card guide rail.

3. Carefully slide the MIC-5332 into the system until the connector contacts start to

mate into the backplane. Make sure the front panel alignment pin falls into the

receptacle.

Figure 3.5 Alignment pin slides into the receptacle

4. Hold both handle ejectors on either side of the board, and then close them to

make the board becomes fully seated. Make ensure the handles are latched

securely.

5. Fasten the retaining thumbscrews.

6. The blue hot-swap LED on the front panel will show a “ONÆBlinkÆOFF”

transition to indicate a normal power-on sequence of the MIC-5332. Once the FW

and payload has been successfully activated, the PICMG 3.0 LEDs will be shown

as below:

Out of Service Health Hot swap

Table 3.1 PICMG3.0 LEDs Definition

All the LEDs status shown on the front panel is listed in Section 3.6, Jumper Setting &

LED Definition.

Retaining Thumbscrews

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 128 129

Sin comentarios

Advantech MIC-5332 Manual de usuario Pagina 35