Advantech MIC-5332 Manual de usuario Pagina 114
- Pagina / 129
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
A.2.1 LAN controller interface selection
The MMC firmware provides an OEM IPMI command to allow users to switch the
MMC connected NC-SI interface between one front panel LAN IO RJ-45 connector
and the Base interface. These commands can be used to read out the actual selected
IPMI-over-LAN / Serial-over-LAN interface and to change the selection.
LAN controller interface selection settings:
00h: Front panel LAN IO
01h: Base Interface LAN BI (default)
Read LAN Interface selection:
Response:
Change LAN Interface selection:
Response:
A.2.2LAN controller channel selection and priority
In addition to the selected LAN controller interface, users may need to configure each
single LAN controller channel (port) as dedicated NC-SI interface to the BMC.
Additional OEM commands for the configuration of the NC-SI LAN controller channel
selection and priority are provided to allow a flexible configuration.
LAN channel selection priority setting list:
0 = The first channel that links up, gets the NC-SI connection to the BMC.
1 = Channel 1 is the preferred port if it is up, otherwise use channel 2 if it is up.
2 = Channel 2 is the preferred port if it is up, otherwise use channel 1 if it is up.
3 = Channel 1 is the only allowed port, always use it, never change to channel 2.
39 28 00
ipmitool raw 0x2e 0x40 0x39 0x28 0x00 0x04 0x00 <setting>
39 28 00 <setting>
ipmitool raw 0x2e 0x41 0x39 0x28 0x00 0x04 0x00
- Revision History 2
- Copyright 3
- Acknowledgements 3
- Product Warranty (2 years) 3
- Declaration of Conformity 4
- Warnings, Cautions and Notes 5
- Document Feedback 5
- Packing List 5
- Safety Instructions 6
- We Appreciate Your Input 6
- Glossary 8
- Chapter 1 10
- Product Overview 10
- 1.1 MIC-5332 Overview 11
- 1.2 Block Diagram 13
- 1.3 Product Configurations 14
- 1.4 Related Products 14
- Chapter 2 15
- Board Features 15
- 2.1 Technical Data 16
- 2.2 Product Features 17
- 2.2.3 DMI Gen2 18
- 2.2.5 Redundant BIOS Flash 19
- 2.3 DDR3 DIMMs 20
- 2.3.2 RAS Mode 21
- 2.4 Ethernet Interface 22
- 2.4.2 Fabric Interface 23
- 2.4.3 I/O Ethernet Interface 23
- 2.5 Zone 3 Interface (RTM) 24
- Chapter 3 26
- Installation 26
- 3.1 Processor 27
- 3.2 Memory 27
- 3.3 Console Terminal Setup 28
- 3.3.2 Terminal Emulator 32
- 3.3.3 PuTTY Configuration 33
- 3.4 Installing the MIC-5332 35
- 3.4.2 FMM (Option) 36
- 3.4.3 RTM (Optional) 39
- 3.4.4 Storage (Optional) 39
- 3.4.5 Front Panel 39
- 3.4.6 LED Definition 40
- 3.4.7 Jumper Settings 42
- JP5 JP6 43
- Chapter 4 44
- Hardware Management 44
- 4.1 Overview 45
- 4.3 Board Information 48
- 4.3 Sensors 50
- 4.3.1 Voltage Sensors 52
- 4.3.2 Thermal Sensors 53
- 4.3.3 Discrete sensors 55
- 4.3.4 Integrity Sensor 56
- 4.4 Watchdog Timers 57
- 4.5 E-Keying 58
- 4.6 Serial-over-LAN (SoL) 58
- 4.6.2 SoL Preparation 59
- 4.6.3 SoL Establishment 61
- 4.7 Dynamic Power Budgeting 66
- 4.8 MAC Address Mirroring 67
- 4.9 RTC Synchronization 68
- Chapter 5 70
- AMI APTIO BIOS Setup 70
- 5.1 Introduction 71
- 5.2 Entering Setup 71
- 5.3 Main Setup 72
- 5.4.1 PCI Subsystem Settings 75
- 5.4.4 WHEA Configuration 77
- 5.4.5 CPU Configuration 78
- 5.4.6 Runtime Error Logging 79
- Start Unit command 82
- will take before it 82
- 5.4.12 Network Stack 84
- 5.4.13 iSCSI 85
- 5.5 Chipset Setup 86
- 5.5.1 North Bridge 87
- 5.5.2 South Bridge 88
- 5.7 Boot Setup 91
- 5.8 Security Setup 92
- 5.9 Save & Exit Option 93
- Chapter 6 95
- Firmware Upgrade 95
- 6.2 IPMItool 96
- 6.3 BMC Upgrade 96
- 6.4 FPGA Upgrade 98
- 6.4.3 Payload Reset 100
- 6.5 BIOS Upgrade 101
- 6.5.1 Upload new BIOS image 102
- 6.5.3 Payload Reset 103
- 6.6 NVRAM Upgrade 104
- <section> 105
- 6.6.2 Upload new NVRAM image 106
- 6.6.4 Payload Reset 107
- Appendix A 108
- 39 28 00 114
- 39 28 00 <setting> 114
- 39 28 00 <POST Code> 117
- 39 28 00 <MAC-Address> 118
- Appendix B 119
- Appendix C 121
- Appendix D 124
- Zone 3 J32 pin out 125
- Zone 3 J34 pin out 125
- Appendix E 127
Relacionado con productos y manuales para Redes Advantech MIC-5332
Redes Advantech FWA-3180 Especificaciones
(22 paginas)
(22 paginas)
Redes Advantech USB-4750 Manual de usuario
(24 paginas)
(24 paginas)
Redes Advantech POC-195 Manual de usuario
(2 paginas)
(2 paginas)
Redes Advantech PC-LabCard PCI-1784 Especificaciones
(57 paginas)
(57 paginas)
Redes Advantech EKI-7529MI Manual de usuario
(1 paginas)
(1 paginas)
Redes Advantech PCM-3350 Manual de usuario
(96 paginas)
(96 paginas)
Redes Advantech UNO-2170 Manual de usuario
(4 paginas)
(4 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.256 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales