Advantech MIC-3369C Guía de instalación Pagina 138

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 161
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 137
Dialogic
®
System Release 6.1 CompactPCI for Windows
®
Release Update 138
Update to Chapter 10, Brazil R2 Bidirectional Protocol Parameter Configuration
The “Values” section for the CDP_FLAG_APPEND_F parameter should be updated
to refer to the CDP_SKIP_A3_AND_A4_PULSE parameter as follows:
Values:
0 [default]: No tone will be sent to the remote end. In this case, A3 or A4 pulse is
expected to be received from the remote end. In a case of overlapped sending
(see description of CDP_OVERLAP_SENDING_ENABLED parameter), the
remote end may also send A1 to request more information.
To skip the A3 or A4 pulse and send ANI immediately after DNIS, set
CDP_SKIP_A3_AND_A4_PULSE=1.
1: ‘f’ (I-15) will be sent to the remote end, indicating the end of information.
3.3 OA&M Documentation Updates
This section contains updates to the following documents (click the title to jump to the
corresponding section):
Dialogic
®
System Release 6.1 CompactPCI for Windows
®
Administration Guide
Dialogic
®
SNMP Agent Software for Windows
®
Administration Guide
Dialogic
®
System Software Diagnostics Guide
Dialogic
®
Board Management API Library Reference
Dialogic
®
Event Service API Programming Guide
Dialogic
®
Event Service API Library Reference
Dialogic
®
Native Configuration Manager API Programming Guide
Dialogic
®
Native Configuration Manager API Library Reference
3.3.1 Dialogic
®
System Release 6.1 CompactPCI for Windows
®
Administration Guide
Update to Chapter 4, Administrative Utilities
The following procedures for checking the firmware version and upgrading the
firmware for Dialogic
®
IPT Boards should be added.
IPT Board Firmware Update Utility
The IPT Board Firmware Update utility facilitates the updating of the firmware residing in
flash memory on a Dialogic
®
IPT Board. In order to perform this procedure, the board
needs to be powered up and properly displayed by the Dialogic
®
Configuration Manager
(DCM).
First, to determine the version of firmware running on the IPT Board:
1. In the DCM, select the IPT Board to upgrade, right-click on it, and choose Configure
Device.
2. Go to the Software Constants property sheet.
Vista de pagina 137
1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 160 161

Comentarios a estos manuales

Sin comentarios