Advantech MIC-3369C Guía de instalación descargar pdf (Pagina 135)

Dialogic

System Release 6.1 CompactPCI for Windows

Release Update 135

Update to Section 4.3, Starting the Configuration Manager (DCM)

In the instructions regarding the Computer Name dialog box for remote DCM, the

following note should be added:

Note: In order to use remote DCM, the local computer (management node) and

remote computer (managed node) must both be running the same Dialogic

software release (for example, System Release 6.1 CompactPCI Windows)

and same build number. If you try to connect to a remote computer with a

different software release or build number, the following message is

displayed:

An incompatible version of the Dialogic(R) System Release

Software is installed on the remote system

and the software releases and build numbers for the two systems are shown.

Update to Section 5.12, Trunk Configuration Property Sheet

The Guidelines at the end of the section (for Trunk1 to Trunk16 parameters) should

be updated as follows (new information is shown in bold):

Guidelines: You can assign different T1 and E1 protocols from the above lists to

different trunks on the same board provided the protocols are all from the same

group. The following values are for Clear Channel signaling: E1CC, ISDNE1CC,

T1CC, and ISDNT1CC. It is recommended to use ISDNE1CC or ISDNT1CC if

mixing ISDN and Clear Channel trunks on the same board. Similarly, use E1CC

or T1CC if mixing a PDK (CAS or R2MF) protocol with Clear Channel signaling

on the same board. After assigning T1 or E1 protocols, use the PDK Configuration

property sheet to assign country dependent parameter files if applicable.

Update to Section 6.8, [0x3b] Parameters

Information about parameters 0x3b03 and 0x3b04 should be added to this section as

follows:

Note: This information is intended for experienced users of the DM3 conferencing

feature. Changing the default parameter settings is not recommended, as

this could introduce negative effects on the audio quality and conferencing

experience of the participants.

CSUMS_ActTalkerPartiesMinNum

Number: 0x3b03

Description: Specifies the number of talkers in a conference before Active Talker mode is enabled.

Note: Conference Active Talker mode, though related, should not be confused with the Active Talker

detection feature.

Values: 0 [default] to 0xff (255).

Guidelines: Refer to the guidelines for the CSUMS_SmartScalingPartiesMinNum parameter

below.

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 160 161

Sin comentarios

Advantech MIC-3369C Guía de instalación Pagina 135