Dialogic
®
System Release 6.1 CompactPCI for Windows
®
Release Update 133
Update to Section 4.1, Installation (IPY00081147)
Add the following note after the first paragraph:
Note: Due to changes in the Dialogic
®
Software install process, an update install
should not be used when updating to a more recent build from a Dialogic
®
System Release 6.1 CompactPCI for Windows build prior to Service Update
176. Update install does work when upgrading from Service Update 176 to
any more recent build.
In Chapter 6, New Global Call Features for ISDN Technology, the “Programming
Libraries” section describes the following feature but omits some of the boards supported:
Support for QSIG NCAS
The ability to make (outbound) and receive (inbound) Non-Call Associated Signaling
(NCAS) calls is supported for the QSIG protocol (E1 or T1) on the Dialogic
®
DMV1200BTEC, DM/V960A-4T1-cPCI and DM/V1200A-4E1-cPCI Boards. The
feature is only supported on media loads that use the QSIG T1 or E1 protocol; for
example, ml2_qs2_qsige1. See the Dialogic
®
Global Call ISDN Technology Guide for
more information. Note that the QSIG NCAS feature is also supported on the
Dialogic
®
DM/IP products too.
3.2 Installation and Configuration Documentation
Updates
This section contains updates to the following documents (click the title to jump to the
corresponding section):
• Dialogic
®
System Release 6.1 CompactPCI for Windows
®
Software Installation Guide
• Dialogic
®
DM3 Architecture for CompactPCI on Windows
®
Configuration Guide
• Dialogic
®
IPT Series on Windows
®
Configuration Guide
• Dialogic
®
Global Call Country Dependent Parameters (CDP) for PDK Protocols
Configuration Guide
3.2.1 Dialogic
®
System Release 6.1 CompactPCI for Windows
®
Software Installation Guide
Update to Chapter 4, Troubleshooting
In Section 4.4, Error Messages, a subsection should be added for the following
issue:
Installation of the DetectorsProj Service Fails
A problem has been observed on multiple Windows
®
2003 systems where an error
occurs during the installation of the Dialogic
®
System Release Software. A pop-up
error message box is displayed when the installation of the DetectorsProj service
fails. It has been determined that this error is due to some other software package de-
registering the Microsoft
®
ATL.DLL file. This file is not delivered as part of the
Comentarios a estos manuales