
Dialogic
®
System Release 6.1 CompactPCI for Windows
®
Release Update 111
Resolved IPY00032797 -- 135 DM3 Fax The fax sender cannot wait to receive retry of digital
identification signal (DIS) message, and gets Phase
E status (EFX_COMMERRTX) transmit
communication error.
Resolved IPY00078445 -- 178 DM3 Firmware When using Dialogic
®
DM3 DM/V-B Boards, DSP
crashes “KillTask” were seen in the DebugAngel log
during standard playback; the affected channels
could not be recovered without a board
reinitialization.
Resolved IPY00045440 -- 176 DM3 Firmware Dialogic
®
DM/V-B Board could not detect DTMF
digits when digits are on about 0 dB per frequency.
Resolved IPY00045388 -- 176 DM3 Firmware Playing a wave file with an invalid byte count in the
header caused Dialogic
®
DM3 firmware to crash.
Resolved IPY00045277 -- 176 DM3 Firmware An intermittent, partial PCM data stream corruption
on network interface channels on Dialogic
®
DM/V1200BTEP Media Boards was observed
during a local loopback mode test where every
channel loops back its incoming stream out to the
network.
Resolved IPY00044832 -- 174 DM3 Firmware Under certain conditions and tone templates for a
dx_playtone( ) in asynchronous mode, the
application does not receive the TDX_PLAYTONE
event on the voice channel.
Resolved IPY00043077 -- 168 DM3 Firmware Inbound ISDN calls made from cell phone failed to
get answered on system connected to NET5 line.
The calls get rejected with STATUS message with
cause value of “100”, which indicates invalid
information element contents. The Progress
Indicator IE containing Progress Description 16 and
Progress Location 1 is being rejected.
Resolved IPY00041740 -- 157 DM3 Firmware Local pool size for GTD needs to be increased for
Dialogic
®
DMV-B Boards.
Resolved IPY00041580 -- 157 DM3 Firmware Over time (usually past 24 hours), dialed DTMFs
get corrupted. When a '5' is dialed, the digit might
get repeated in fragmented stutter and/or followed
by an '8' even though never specified in the
dialstring.
Resolved IPY00043545 -- 166 DM3 Host Runtime
Library
Call to ipm_Close( ) hangs with Dialogic
®
DI/0408-
LS Switching Board if there are no additional DM3
voice resources in the system.
Resolved IPY00043430 -- 165 DM3 Host Runtime
Library
After performing a peripheral hot swap of Dialogic
®
DM/IP Boards, and boards are successfully
restarted, gc_OpenEx( ) fails to open on-board
IPML devices, returning error 0x44, Invalid
Parameter.
Issues Sorted By Type, Dialogic
®
System Release 6.1 CompactPCI for Windows
®
(Continued)
Issue Type Defect No.
PTR
No.
SU
No.
Dialogic
®
Product(s) or
Component(s)
Description
Comentarios a estos manuales