Advantech Data Acquisition Modules ADAM 4000 Manual de usuario descargar pdf (Pagina 398)

100

101

Appendix D

Appendix D Utility Software D

-3

NOTICE: When changing configuration, calibration or alarm

parameters, you should always make sure that a window appears

notifying you that the target module has confirmed the changes.

An asterix sign “*” before the modules address indicates that the

module is in the INIT* state

Configuration

Click the searched module, which you would like to configure. You

will find Setup page and related settings. An example is shown in

Figure D-2 for an ADAM-4011 module.

Figure D-2 Configuration Screen

Here there are three major areas, General Setting, Data Area and AI

Calibration. You may change the settings by selecting the preferred

items and then clicking Update button.

The Checksum and Baud rate options need special attention since they

can only be changed when an ADAM module is in the INIT* state. To

place a module in INIT state, its INIT terminal should be connected to

its GND terminal (see Baud rate and Checksum in Chapter 2). When

the ADAM module is not in INIT mode, an error message will appear.

1 2 ... 393 394 395 396 397 398 399 400 401 402 403 ... 428 429

Comentarios a estos manuales

Sin comentarios

Advantech Data Acquisition Modules ADAM 4000 Manual de usuario Pagina 398

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Advantech Data Acquisition Modules ADAM 4000