Advantech RSB-4210 Evaluation Kit Manual de usuario descargar pdf (Pagina 17)

9 RSB-4210 User Manual

Chapter 2 H/W Installation

2.1.15 Power Cord (Part-L)

3P Power Cord (USA, Europe or UK standard) for 19 V Power Adapter AC input.

2.1.16 Speaker & Audio Cables (Part-M)

The cable connects with RSB-4210 (AUDIO1) and LINE-OUT, LINE-IN, MIC-IN and

L&R Speakers.

2.1.17 Power Cable for Charger Board (Part-N1)

The cable provides the power for charger board. It connects RSB-4210 (BAT_CN1)

with the charger board (CN2).

2.1.18 Signal Cable for Charger Board (Part-N2)

The cable provides the control signal for charger board. It connects RSB-4210

(BAT_CN2) with the charger board (CN1).

2.1.19 Charger Board (Part-N3)

The charger board provides 12v power to charge the battery when plug-in a 19v

adapter, and RSB-4210 can read the battery status through this charger board.

2.1.20 Battery (Part-N4)

The battery can provide the power with RSB-4210 without any adapter.

2.1.21 Keypad Cable (Part-O1)

The keypad cable connects RSB-4210 (KEYPAD1) with the keypad.

2.1.22 Keypad (Part-O2)

8*8 arrays of 64 normally open single-pole switches. (6*6 region of keypad are avail-

able when using RSB-4210.)

2.1.23 Cable for Suspend/Reset Button (Part-P)

The cable is used to extend the Suspend/Reset function by a specific button.

2.1.24 COM Port Cable (D-SUB 9P to Housing) (Part-Q)

The cable is used to extend COM port 9pin header from RSB-4210 to D-SUB 9P

serial port connector.

2.1.25 RS-232 Loopback (Part-R)

The terminal connector 9P female is used to test RS-232 loopback function.

2.1.26 Terminal Block for CAN/RS-485 (Part-S)

The terminal block can be extended with extra two cables to connect RSB-4210

CAN/RS-485 function with the others CAN/RS-485 devices.

Note! It is necessary to use 19v adapter for charger board rather than 12v.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 103 104

Sin comentarios

Advantech RSB-4210 Evaluation Kit Manual de usuario Pagina 17