Chapter 3: Installation and Configuration 31
The ADAM-4570 is ready to be configured and is now
waiting for acknowledgement from the device.
“Lost Connection from the Device”
Due to device shut down or network failure, the configuration
utility has lost connection after 5 seconds.
“Fail to apply this setting to the device”
Specific settings are not accepted by ADAM-4570.
“The device fails to respond”
The connected device does not respond.
“Fail to reset the device”
Fail to reset the ADAM-4570.
3.3.1 Connection Diagnostic
When you complete the configuration of your ADAM-4570s,
you can follow the steps to check if the ADAM-4570 con-
nects to network or not.
1. Execute the Microsoft DOS program.
2. Execute “PING” command and type your IP address of
ADAM-4570. If ADAM-4570 connects to your network,
it will display in the screen. If the ADAM-4570 cannot be
pinged, you will need to ask someone at the remote site to
Comentarios a estos manuales