Advantech AIMB-766 Manual de usuario descargar pdf (Pagina 19)

11 IPC-630 User Manual

Chapter 2 System Setup

2.5 Installing Disk Drives

The disk drive housing supports three 5.25" and two 3.5" disk drive devices. Please

follow these steps for installation.

1. Undo the four screws on the top of the disk drive housing and then lift it up. (see

Figure 2.8)

2. Loosen the two screws on top left of the housing to remove the brackets for fix-

ing the 3.5" FDD or HDD. And then remove the screws on both sides of the front

covers in case the user needs to install the front-accessible disk drives. (see

Figure 2.9)

3. Insert the disk drives into the proper location in the disk drive housing, and

secure them with the supplied screws. (see Figure 2.10)

4. Connect the suitable cables (ex. IDE, SCSI, SATA or SAS, etc.) from the CPU

card or motherboard to the various disk drives.Then plug the power connector

into each disk drive.

5. Replace the disk drive housing and fasten it with the four screws.

Figure 2.8 Removing the disk drive housing

Figure 2.9 Removing the 3.5" FDD brackets and front covers

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 41 42

Sin comentarios

Advantech AIMB-766 Manual de usuario Pagina 19