
7 IPC-630 User Manual
Chapter 2 System Setup
2.2 Installing the Backplane or Motherboard
The IPC-630 supports either up to 15-slot backplane or ATX/microATX motherboard.
To install the backplane or motherboard, please proceed as follows:
1. Dismantle the hold-down clamp by undoing the two screws on its both ends.
2. There is a yellow warning label located inside of the chassis bottom. (see Figure
2.2) It shows the screw locations for attaching the various backplanes or moth-
erboards. Be sure to follow the instruction and fasten the backplane or mother-
board onto the chassis with the correct screw locations.
3. While installing a BACKPLANE, fasten it in place and attach the supplied EMI
spring shielding with the screws provided.
4. For the PICMG 1.0 BACKPLANE, connect the orange-white wire from connec-
tor, HCN1, on the backplane to connector, CN21, on the CPU card.
5. While installing a MOTHERBOARD, attach the motherboard I/O shielding onto
the rear plate first. Then fasten the motherboard onto the chassis.
6. Connect the 20-pin (or 24-pin) ATX power connector and the 4-pin +12V power
connector from the power supply to the backplane or the motherboard. (For the
PICMG 1.0 BACKPLANE, the 4-pin +12 V power connector is connected to the
CPU card.)
7. Connect the 9-pin USB wire, PS/2 wire, Power switch wire, and the System
Reset switch wire from the chassis to the motherboard.
8. Connect the wire of HDD LED from the chassis to the motherboard.
Figure 2.2 Yellow label indicating copper stub locations
AIMB-744
Be careful to screw the Copper Stub under 10 kgf cm.
AIMB-750
AIMB-760
AIMB-542
AIMB-762
AIMB-554
PCA-6114P12
PCA-6115
PCE-5B12-64
AIMB-742
AIMB-740
PCA-6114P12X
PCE-7B13-64
PCA-6113P7X
PCA-6114P10
PCA-6114P4
PCA-6114-B
PCA-6113P4R
PCA-6114P7
BP/MP MODEL
NUT NUMBER
221154
21
3910867 16151312 14 20 2117 18 19 27262423 25 MAX28 29
AIMB-556
AIMB-560
AIMB-562
AIMB-764
Comentarios a estos manuales