Advantech SBD75e Series Especificaciones descargar pdf (Pagina 23)

Installation

2.6 Signal Connections

The majority of signal connectors are located on the rear panel of the SBD75e Demodulator,

except for one monitor and control connector located on the front panel.

Note

Always use the specified cables supplied for signal integrity and compliance with EMC requirements

(see appendix A, Technical Specification).

2.6.1 M&C Connector - RS232

An RS-232 connector, provided at the rear panel, supports the connection of ANSII 3.64 VT-100

terminals (including hand-held) similar to the front panel RJ-11 connector.

Table 2.4: M&C Connector - RS232

Item Specification

Connector type: 9-way, D-type, Female

Connector designation: M&C RS232

Standard: RS232

Configuration: DCE

Pin-outs: 1 Not Used 6 Not Used

2 Tx Data 7 Not Used

3 Rx Data 8 Not Used

4 Not Used 9 +5 VDC @ 100 mA

5 Ground

2.6.2 M&C Connector - 10/100BaseT Ethernet

There is one 10/100BaseT Ethernet M&C ports which is labelled M&C Demod.

Table 2.5: M&C Connector - 10/100BaseT Ethernet

Item Specification

Connector type: RJ-45 socket

Connector designation: M&C Demod

Standard: 10/100BaseT

Configuration: -

Pin-outs:

RJ-45 Pin Number Description Wire Color Codes Crossover Cable Pins

1 TX + White W/Orange 3

2 TX - Orange 6

3 RX + White W/Green 1

4 Blue

5 White W/Blue

1 8

SBD75e Series Demodulator Installation and Operation Manual

2-9

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 96 97

Sin comentarios

Advantech SBD75e Series Especificaciones Pagina 23