Advantech PCI-1612 Manual de usuario descargar pdf (Pagina 39)

29 Chapter 2

2.3 Jumper Settings

This section tells how to set the jumpers to configure your card. It gives

the card default configuration and your options for each jumper.

2.3.1 How to Set Jumpers

You configure your card to match the needs of your application by setting

jumpers. A jumper is the simplest kind of electric switch. It consists of

two metal pins and a small metal clip (often protected by a plastic cover)

that slides over the pins to connect them. To “close” a jumper you connect

the pins with the clip. To “open” a jumper you remove the clip.

Sometimes a jumper will have three pins, labeled 1, 2 and 3. In this case

you would connect either pins 1 and 2 or 2 and 3.

You may find a pair of needle-nose pliers useful for setting the jumpers.

If you have any doubts about the best hardware configuration for your

application, contact your local distributor or sales representative before

you make any changes.

Figure 2.19: How to Set Jumpers

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 105 106

Sin comentarios

Advantech PCI-1612 Manual de usuario Pagina 39