Advantech PCM-9363 Manual de usuario descargar pdf (Pagina 23)

13 PCM-9363 User Manual

Chapter 2 H/W Installation

This allows no-keyboard operation in embedded system applications, without the

system halting under POST.

2.2.2.9 SMBus Connector (CN11)

The System Management Bus (abbreviated to SMBus or SMB) is a simple two-wire

bus, derived from I

C and used for communication with low-bandwidth devices on a

motherboard, especially power related chips such as a laptop's rechargeable battery

subsystem (see Smart Battery Data). Other devices might include temperature, fan

or voltage sensors, lid switches and clock chips. PCI add-in cards may connect to a

SMBus segment.

The SMBus was defined by Intel in 1995. It carries clock, data, and instructions and

is based on Philips' I

C serial bus protocol. Its clock frequency range is 10 kHz to

100kHz. Its voltage levels and timings are more strictly defined than those of I

C, but

devices belonging to the two systems are often successfully mixed on the same bus.

2.2.2.10 Inverter Power Connector (CN13)

PCM-9363 can provide +5 V and +12 V and signal to LCD inverter board via CN13.

2.2.2.11 USB Connectors (CN14, CN15, CN24, CN25)

The board provides up to six USB (Universal Serial Bus) ports. This gives complete

Plug and Play, and hot attach/detach for up to 127 external devices. The USB inter-

faces comply with USB specification Rev. 2.0 which supports 480 Mbps transfer rate,

and are fuse protected.

There are 5 x 2 pin 180D (M) connectors for internal use, 4 x USB ports at CN14,

CN15 and two external USB port at CN24,CN25. You will need an adapter cable if

you use a standard USB connector. On one end the adapter cable has a 5 x 2-pin

connector with a foolproof connection to prevent it from being plugged in the wrong

way and on the other end a USB connector.

2.2.2.12 VGA/LCD/LVDS Interface Connections

The board's PCI VGA interface can drive conventional CRT displays and is capable

of driving a wide range of flat panel displays, including passive LCD and active LCD

displays. The board has connectors to support these displays: one for standard CRT

VGA monitors and one for flat panel displays

CRT display connector (CN27)

The CRT display connector is a box header connector used for conventional CRT

displays.

LVDS LCD panel connector (CN16)

The board supports 18 or 24 bit LVDS LCD panel displays. Users can connect to a 18

or 24 bit LVDS LCD on it.

HDMI panel connector (CN22)

HDMI panel connector is optional for PCM-9363DH-S8A1E. It supports FHD resolu-

tion 1080P LCD panel.

2.2.2.13 Ethernet Configuration (CN18, CN19)

10/100/1000 Mbps connections are made via RJ-45 connectors.

The board is equipped with 2 high performance PCI Ethernet interface which is fully

compliant with IEEE 802.3u 100Base-T & IEEE 802.3ab 1000Base-T. It is supported

by all major network operating systems.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 97 98

Comentarios a estos manuales

DarrickBuili 20 Feb 2024 | 21:26:55

Hello Guys, Glad to Join! :)

Advantech PCM-9363 Manual de usuario Pagina 23

Comentarios a estos manuales

Relacionado con productos y manuales para Placas base Advantech PCM-9363