Advantech EDG-4508R+ Manual de usuario descargar pdf (Pagina 68)

EDG-4508(R)+/4516(R)+ User Manual 62

4.3 Inquiring Virtual COM Port Setting

You can check the virtual COM port setting by clicking on the EDG

device’s ports. In this case, COM11 is assigned to Port 1 of EDG-4516+.

4.3.1 Self Test Function

Test

The purpose of this test is to confirm that the communication from the

host PC to the EDG device is OK. When the test is selected, an external

test will be performed to check that the connection signal between each

port is working properly. For this test, you will need to connect each port

to a Loopback tester. Refer to the following chart for specifications of this

Loopback tester. The Loopback test only applies to RS-232 mode. It is

divided in two parts: Signal test and Communication Parameters test.

1. Click on the Test button in the Port Mapping utility. A message will

confirm that the loopback connector have already been connected

with the EDG COM port. If ready, click the Start button to start the

test.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 107 108

Sin comentarios

Advantech EDG-4508R+ Manual de usuario Pagina 68