
9 Chapter 2
2.3 Connecting Hardware
This section introduces how to connect EDG-4508(R)+ or EDG-
4516(R)+ to serial devices for first time.
2.3.1 Rack Mounting
2.3.2 Network Connection
Connect the Ethernet cable to EDG-4508(R)+ or EDG-4516(R)+
Ethernet port. There are 2 LED indicator located on front panel to show
the Ethernet status. If the cable is connected correctly, the LAN LED will
indicate a valid connection to the Ethernet in the following ways:
LED Status Description
Speed Green 100M bps
Off 10M bps
Link/Active Off No Ethernet data being received or trans-
mitted
Blinking Ethernet data being received/transmitted
Note Speed LED will keep the last status even though the
Ethernet cable is disconnected. While EDG reboot or
re-plug in the Ethernet cable, EDG will detect
Ethernet LAN speed.
Comentarios a estos manuales