Advantech DVG-1100W Manual de usuario descargar pdf (Pagina 33)

DVG-1100 Video Server Manual

Page 33 of 43

6.2.7. ALARM EVENT

 Embedded Motion Detection Setting

¾ Set Motion Detect Region：

Set up motion detection region. Click “Begin “, choose range 0~15 and click “Edit Region “, and then

you can drag-drop a square region on video. If want to cancel the region, please click “Remove Region

“. And Click “End Edit “to stop the event.

¾ Sensitivity：The value is smaller, the sensitivity is higher.

¾ Motion Detection enabled：Enable or disable motion detection.

 Embedded Motion Detection Event：

Send E-mail with a JPEG or upload to FTP with *.AV file.

 I/O & Alarm Setting：

Set up the I/O input port and relay-output status.

¾ Isolated Input：Can set up alarm level and alarm event.

<1> Alarm Level：Have three kinds of type: low alarm, high alarm and no alarm.

When the GPIO normal input is a high level, then select " low level " ;

When the GPIO normal input is a low level, then select " high level ”. Default: No alarm.

<2> Alarm Event：When GPIO alarm was triggered, it can select corresponded alarm event：

 Send E-mail with a JPEG picture

 Upload .AV file to FTP Server.

¾ Output Relay Control: There are three dry contact output of relay-output.

 NO and COM: two pins will normally “OPEN”, when control signal level = low.

 NC and COM: two pins will normally “CLOSE”, when control signal level = low.

When user set control signal level to “High”, the status will reversed.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 42 43

Sin comentarios

Advantech DVG-1100W Manual de usuario Pagina 33