vii
b. Liquid has penetrated into the equipment.
c. The equipment has been exposed to moisture.
d. The equipment does not work well, or you cannot get it to work
according to the user's manual.
e. The equipment has been dropped and damaged.
f. The equipment has obvious signs of breakage.
The sound pressure level at the operator's position according to IEC 704-
1:1982 is no more than 70 dB (A).
DISCLAIMER: This set of instructions is given according to IEC 704-1.
Advantech disclaims all responsibility for the accuracy of any statements
contained herein.
Safety Precaution - Static Electricity
Follow these simple precautions to protect yourself from harm and the
products from damage.
1. To avoid electrical shock, always disconnect the power from your
PC chassis before you work on it. Don't touch any components on
the CPU card or other cards while the PC is on.
2. Disconnect power before making any configuration changes. The
sudden rush of power as you connect a jumper or install a card may
damage sensitive electronic components.
NOTE: Do not leave this equipment in an environment
where the storage temperature may go below
-20° C (-4° F) or above 60° C (140° F). This could
damage the equipment. The equipment should be
in a controlled environment.
CAUTION: Danger of explosion if battery is incorrectly
replaced. Replace only with the same or equiva-
lent type recommended by the manufacturer, dis-
card used batteries according to the
manufacturer’s instructions.
Comentarios a estos manuales