
Chapter 2 System Setup
9
Chapter 2 System Setup
Installation procedures for the IPC-644 are described below.
WARNING: Before starting the installation procedures,
make sure you disconnect all power from the
chassis. Unplug the power cord from the
power outlet in the wall. Merely turning off
the power switch is not sufficient. If you are
not sure what to do, consult an experienced
technician.
2.1 Removing the Top Cover
The first step is to remove the chassis cover. You will need a
philips screwdriver to detach all of the 6 screws. Then lift off
the cover.
Figure 2-1: Removing the top cover
Comentarios a estos manuales