Advantech IPC-5120 Manual de usuario descargar pdf (Pagina 23)

15 Chapter 2

2.4 Installing Disk Drives

To install a CD-ROM drive (or CD-R/W drive or DVD-ROM drive),

HDD or FDD, please refer to these detailed procedures:

1. Loosen the four screws on top of the disk drive housing and then

lift it up.

2. Users can remove the 3.5" disk drive bracket completely from the

housing by loosening the two screws and then separating it from

the hooks by sliding it backwards. (see Figure 2.6)

3. Insert the disk drive into the proper location in the disk drive hous-

ing, and fix it with the supplied screws. (see Figure 2.7)

4. Connect a 34-pin flat cable from the motherboard to a FDD, or a

40-pin flat cable to the IDE HDD or CD-ROM drive (or CD-RW

drive or DVD-ROM drive, etc.), or a SATA cable to a SATA HDD.

Then plug the power connector in to each disk drive.

5. Replace the disk drive housing and then fasten it with four screws.

6. There is another disk drive bracket fixed on the inside of the rear

plate. If users want to install a 3.5" HDD, simply unfasten the four

screws from outside of the rear plate and then remove it from the

hook. (see Figure 2.8)

7. Fasten the HDD into this bracket properly. The

four screws used to fasten the bracket are

supplied with rubber cushions; the

rubber cushions should be

inserted between the HDD and

the chassis when fastening the

screws. The cushions protect

the HDD from shock and

vibration.

8. Replace this bracket to the

hook and fasten the four

screws from outside of the rear

plate.

Figure 2.6: Removing the 3.5" disk drive bracket

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 43 44

Sin comentarios

Advantech IPC-5120 Manual de usuario Pagina 23